Hardware

The hardware design is created with the open-source Horizon EDA (horizon-eda.org). After installing Horizon EDA, open the corresponding .hprj project file in this directory.

The Buce module in this project requires a 0.5” (1.27 mm) pitch 6-pin programming clip. Alternatively, you can use a general ESP32-C3 development board.

Note

Using a third-party development board such as the XIAO-ESP32C3 is intended only for initial firmware testing. Except for Wi‑Fi connectivity, LED dimming PWM outputs, and the fan PWM output, other features depend on the peripheral circuits on the custom PCB used in this project.

A typical programming clip for reference